Setting up a Brick Paver Walkway or Building Brick

The usage of Bricks or Pavers to produce a walkway or patio area matches a home in a method that is unrivaled. In addition, installing a Brick or Paver sidewalk does not necessarily require a pro.

The secret to setting up a Brick or Paver Walkway is to very first correctly prepare the area where the bricks/pavers are to be set up. The area must be dug out a minimum of a foot down, removing all topsoil and clay soil. In addition, string lines need to be strung on each side of the pathway. The string lines show the completed height of the sidewalk.
As soon as the area has been dug down, 3/4" gravel stone must be laid in and tamped down tightly. 2" of sand, or stone dust should be spread over the gravel. Again the sand/stone dust ought to be tamped down. Stone dust is chosen. The height between the tamped down sand and the stringline must equal the thickness of the brick or paver.

Now that you have a steady base, put a 1" pipe or ledger board the length of the walkway on either side of the pathway. Then utilizing a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Set up a work on both sides of the prepared location. These strips will serve as your sidewalk border and help to preserve the stability and shape of the sidewalk. You can get these plastic strip borders at the majority of home enhancement shops. The strips should be anchored down with 12" galvinized nails. You ought to sink these nails into the ground and through the strips every foot.

The secret to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger nearby rows of bricks by 1/2 of a check here brick to interlock them. This will again assist preserve the stability of the pathway.

Undoubtedly bricks/pavers will need to be cut or divided when building the sidewalk. To really cut/split the brick/paver, lay it in a bed of sand and location the chisel at a 75 degree angle over the area where you want to break the brick. If your pathway has curves you will need to buy/rent a wetsaw.

After setting up the bricks, build up the outdoors edges with extra sand, and then shovel in the topsoil and load down firmly.
Spread stone dust over the new pathway and sweep into the fractures. This will complete the interlocking of the bricks and help to get rid of any weed development.


In addition, more info installing a Brick or Paver walkway does not always require a pro. The key to setting up a Brick or Paver Walkway is to very first effectively prepare the area where the bricks/pavers are to be installed. Now that you have a steady base, put a 1" pipeline or ledger board the length of the walkway on either side of the sidewalk. These strips will act as your walkway border and help to maintain the stability and shape of the pathway. Undoubtedly bricks/pavers will require to be cut or divided when developing the sidewalk.

Leave a Reply

Your email address will not be published. Required fields are marked *